Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Wiki Markup
h1. FAQ

h2. How can I perform progressive collapse analysis (e.g. remove column and get dynamic response) in SAP2000?

You can simulate the progressive collapse analysis with dynamic effects by running time history analysis as follows:

(1) Create "Model A" that contains the entire structure, including the column to be removed. Analyze Model A to obtain internal forces for the column to be removed.

(2) Create a "Model B" that does not contain the column to be removed. However, simulate the presence of column to be removed by applying end column forces obtained from Model A to the appropriate joints of the model.

(3) Run time history analysis with a load applied at time = 0. The load would be opposite to that applied in step 2 and it would effectively simulate removing the column. You would need to use a ramp function to reduce the loads applied in the time history analysis to zero values in a short time. How short (or long) the time should be would depend on how quickly the column is removed and you should use your judgment to decide this.

{related-email:date=2010-05-06|from=rs|to=ok|subject=Action Request - Progressive collapse capabilies of PERFORM 3D|comment=see [email|$1745561]hidden-content}
* [5/6/2010 email on progressive collapse capabilities of SAP2000|$1745561]
{hidden-content}

h1. References

* [Analytical Tools for Progressive Collapse Analysis|http://www.nibs.org/MMC/ProgCollapse%20presentations/Smilowitz%20paper.pdf] by Robert Smilowitz
* [Dynamic Analysis Procedure for Progressive Collapse|http://www.structuremag.org/Archives/2006-4/SF-Dynamic-Analysis-for-Progressive-Collapse.pdf] by Elizabeth Agnew, and Shalva Marjanishvili; STRUCTURE Magazine, April 2006 - provides some SAP2000 specific information