Wiki Markup | ||
---|---|---|
Warning | ||
| ||
As of SAP2000 V14.0.0, shell reinforcement design is based on Eurocodes. The content of this article will be updated accordingly. {warning} \\ The [SAP2000|sap2000:home] formulation for [shell|kb:Shell] reinforcement design is based on the following publications: * |
The SAP2000 formulation for shell reinforcement design is based on the following publications:
- Brondum-Nielsen,
...
- T.
...
- (1974).
...
...
...
...
...
...
...
...
...
- ,
...
- Report
...
- NR.R
...
- 44
...
- ,
...
- Technical
...
- University
...
- of
...
- Denmark,
...
- Copenhagen,
...
- Denmark.
...
- Marti,
...
- P.
...
- (1990).
...
...
...
...
...
...
...
...
- ,
...
- ACI
...
- Structural
...
- Journal,
...
- 87
...
- (2),
...
- 180-190.
...
The formulation is documented in the technical note Concrete Shell Reinforcement Design, available through Help > Documentation > Technical Notes > Concrete Shell Reinforcement Design.
Setting shell design parameters
Default shell design parameters, such as rebar cover, may be modified through Define > Section Properties > Area Sections, as shown in Figure 1:
Figure 1 - Set default shell design parameters
Reviewing results
After analysis is run, design parameters may be reviewed through Display > Show Forces/Stresses > Shells by selecting the component type Concrete Design, as shown in Figure 2:
Figure 2 - Review design parameters
ASt1 represents reinforcement in the 1 direction of the shell, and ASt2 is in the 2 direction. The reinforcement calculated for either the top or bottom face of the shell object may be displayed separately, as shown in Figure 3:
Figure 3 - Reinforcement for top or bottom surface and orientation
Show if | ||
---|---|---|
| ||
TO DO: Update shell reinforcement design with current Eurocodes. |